产品介绍
1. SCOPE
The purpose of the document is to specify the functional requirements of SinoV-KSK-5V1A USB power.
The SINOV-KSK-5V-AUSB power for Hotel / MDU System Integrator to provide guests and roomers secure Internet access and USB power connection in their hotel room, guest room, living room and lobby.
2. INPUT CHARACTERISTICS
2.1Input Voltage:
Nominal Voltage:~100-240V
Variation Range:~90-265V
2.2Input Frequency:
Nominal Frequency:50/60Hz
Variation Frequency:47-63Hz
2.3Input Current:
2.4Inrush Current:
80Amps Max. Cold start at 240Vac input, with rated load and 25℃ambient.
2.5 Ac Leakage Current:
0.25mA Max At 240Vac input.
3. output characteristics:
3.1 output characteristics
Voltage
|
Voltage Min
|
Rated load
|
Max load
|
Output Power
|
5V
|
0.5W
|
6W
|
8W
|
6W
|
3.2 load characteristic,Adjusted rate
Voltage
|
Voltage Max
|
Rated load
|
Line Regulation
|
Load Regulation
|
5.1-5.25V
|
5.25
|
5V
|
3%
|
5%
|
3.3 Ripple And Noise:
The ripple and noise are as follows when measure with Max. Bandwidth of 25MHz and Parallel 50V/47uF,crossed connected at testing point.
|
|
|
Voltage
|
Ripple And Noise(Max.)
|
|
5.15V
|
200MV
|
3.4Turn On Delay Time:
2 second Max. At 220Vac input and output Max. Load
3.5 Rise Time
40mS Max. At 2205Vac input and output Max. Load
3.6 Hold Up Time:
5mS Min. At 115Vac input and output Max. Load.
3.7 Efficiency:
65%Min.At 220 Vac input and output Max. Load.
65%Min.At 240Vac input and output Max. Load.
4. PROTECTION REQUIREMENT:
4.1Short Circuit Protection:
The power supply will be auto recovered when output less 0.2A
4.2 Over current Protection:
The power supply will be auto recovered when over current faults
5. LED function
Green color when nomr working,Red color when charge,colol change to green when fully charged,trun RED when check current 100ma (+/-20%)
6. ENVIRONMENTAL REQUIREMET:
6.1 Operating Temperature
0℃~ -40℃, Full load Normal operation。
0℃to40℃,Full load Normal operation.
6.2 Storage Temperature:-20℃to85℃, With package.
6.3 Relative Humidity:
5%(0℃)~90%(40℃)RH,72Hrs,Full load Normal operating.
6.4 Vibration:
1、Operating: IEC 721-3-3 3M3
5~9Hz,A=1.5mm 9~200Hz,Acceleration 5m/s2
声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。
举报投诉
-
嵌入式主板
+关注
关注
7文章
6085浏览量
35307 -
源创通信
+关注
关注
0文章
85浏览量
1958
发布评论请先 登录
相关推荐
使用USB和充电器典型应用
的切换,如图4所示。将充电器连接至USB端口后,MCU将检测所连接的充电器并将输出使能(OE)引脚拉高至禁用开关的高度。MCU将与充电器进行通信
发表于 06-04 10:14
4口USB排插厂家直销旅充礼品智能恒压USB充电器插座带万用插
`五种颜色可供选(白、黑、红、绿、蓝),AC插头有英规、美规、欧规、澳规可选择,线长1.2m,4口USB
发表于 10-12 15:30
USB墙式充电器优势及难点
我记得,就在几年前,机场内的USB墙式插座还很少见。而如今,内置USB充电器变得越来越常见,即使在咖啡厅和餐饮连锁店内也能看到它们的身影。目
发表于 11-17 07:05
苹果美规5V/1A充电器A1385拆解报告
5V/1A充电器作为一款经典的产品,用料和做工到底怎样呢?此前已经跟大家分享了港版5V/1A充电器的拆解,本次继续为大家带来美规5V/1A充电器A1385的拆解。 本文引用地址: 一、
USB墙式充电器的便利性,它将面临哪些挑战
插座还很少见。而如今,内置USB充电器变得越来越常见,即使在咖啡厅和餐饮连锁店内也能看到它们的身影。目前,新建房屋都有USB墙式
发表于 11-10 09:40
•704次阅读
USB墙式充电器:便利与挑战
插座盖后面所允许的最大功率耗散为2-3W。对于2个10W的USB端口来说,你需要90%的效率,这样才能将损耗控制在2W以下。当用于商用USB充电器/双孔插座中时,TI的UCC28700 反激式
评论