资料介绍
The NE8392C Coaxial Transceiver Interface (CTI) is a bipolar coaxial line driver/receiver for Ethernet (10base5) and Thin Ethernet (10base2) local area networks. The CTI is connected between the
coaxial cable and the Data Terminal Equipment (DTE) and consists
of a receiver, transmitter, receive-mode collision detector, heartbeat
generator and jabber timer (see Block Diagram). The transmitter
output connects directly to a doubly terminated 50W cable, while the
receiver output, collision detector output and transmitter input are
connected to the DTE through isolation transformers. Isolation
between the CTI and the DTE is an IEEE 802.3 requirement that
can be met on signal lines by using a set of pulse transformers
normally available in a standard 16-pin DIP. Power isolation for the
CTI is achieved using DC-to-DC conversion through a power
transformer (see Figure 1, Connection Diagram).
During transmission the jabber timer is initiated to disable the CTI
transmitter in the event of a longer than legal length data packet.
Receive-mode collision detection circuitry monitors the signals on
the coaxial cable to determine the presence of colliding packets and
signals the DTE in the event of a collision. At the end of every transmission the heartbeat generator creates a pseudo collision for a short time to ensure that the collision circuitry is functioning correctly. The heartbeat function can be disabled for repeater applications.
coaxial cable and the Data Terminal Equipment (DTE) and consists
of a receiver, transmitter, receive-mode collision detector, heartbeat
generator and jabber timer (see Block Diagram). The transmitter
output connects directly to a doubly terminated 50W cable, while the
receiver output, collision detector output and transmitter input are
connected to the DTE through isolation transformers. Isolation
between the CTI and the DTE is an IEEE 802.3 requirement that
can be met on signal lines by using a set of pulse transformers
normally available in a standard 16-pin DIP. Power isolation for the
CTI is achieved using DC-to-DC conversion through a power
transformer (see Figure 1, Connection Diagram).
During transmission the jabber timer is initiated to disable the CTI
transmitter in the event of a longer than legal length data packet.
Receive-mode collision detection circuitry monitors the signals on
the coaxial cable to determine the presence of colliding packets and
signals the DTE in the event of a collision. At the end of every transmission the heartbeat generator creates a pseudo collision for a short time to ensure that the collision circuitry is functioning correctly. The heartbeat function can be disabled for repeater applications.
下载该资料的人也在下载
下载该资料的人还在阅读
更多 >
- 基于AND8392/D交流到直流单输出电源的参考设计
- 终止通知:NanEye NE2D_EN000204_1-00.pdf
- NE555频率计算软件 134次下载
- NE5532数据手册 0次下载
- NE553_datasheet 7次下载
- NE555参数计算 94次下载
- NE555电路智能设计软件下载 478次下载
- PHILIPS NE555N pdf
- NE5234/SA5234 pdf datasheet (M
- NE/SA5234 pdf datasheet
- NE/SA/AU5232 pdf datasheet
- NE5560.pdf
- ne5534.pdf
- ne5532 pdf
- ne555.pdf
- ne5532芯片功能和作用 ne5532工作电压范围 7756次阅读
- 华为eNSP镜像包全集下载,包含CE6800、CE12800、NE系列等! 2.2w次阅读
- NE555时基电路制作的光控报警器 2194次阅读
- 基于NE555的警笛电路图 2162次阅读
- 一文详解NE555方波信号发生器 1.3w次阅读
- 一些有趣的NE555电路 2306次阅读
- 基于NE555的延时电路 1.6w次阅读
- NE555构成的自动延时电路 3.1w次阅读
- ne555和lm555的区别介绍_lm555/ne555 4.7w次阅读
- ne555闪烁灯电路图大全(频闪灯/振荡电路/闪光电路) 4w次阅读
- ne555呼吸灯电路图大全(四款ne555呼吸灯电路设计原理图详解) 8.3w次阅读
- ne555调温电路图大全(六款ne555调温电路) 3.7w次阅读
- ne555可以用什么代替 3w次阅读
- 用NE555设计的恒温控制器的方案 7768次阅读
- 采用NE555的定时器电路图 1w次阅读
下载排行
本周
- 1TC358743XBG评估板参考手册
- 1.36 MB | 330次下载 | 免费
- 2开关电源基础知识
- 5.73 MB | 11次下载 | 免费
- 3嵌入式linux-聊天程序设计
- 0.60 MB | 3次下载 | 免费
- 4DIY动手组装LED电子显示屏
- 0.98 MB | 3次下载 | 免费
- 5基于FPGA的C8051F单片机开发板设计
- 0.70 MB | 2次下载 | 免费
- 651单片机窗帘控制器仿真程序
- 1.93 MB | 2次下载 | 免费
- 751单片机PM2.5检测系统程序
- 0.83 MB | 2次下载 | 免费
- 8基于51单片机的RGB调色灯程序仿真
- 0.86 MB | 2次下载 | 免费
本月
- 1OrCAD10.5下载OrCAD10.5中文版软件
- 0.00 MB | 234315次下载 | 免费
- 2555集成电路应用800例(新编版)
- 0.00 MB | 33566次下载 | 免费
- 3接口电路图大全
- 未知 | 30323次下载 | 免费
- 4开关电源设计实例指南
- 未知 | 21549次下载 | 免费
- 5电气工程师手册免费下载(新编第二版pdf电子书)
- 0.00 MB | 15349次下载 | 免费
- 6数字电路基础pdf(下载)
- 未知 | 13750次下载 | 免费
- 7电子制作实例集锦 下载
- 未知 | 8113次下载 | 免费
- 8《LED驱动电路设计》 温德尔著
- 0.00 MB | 6656次下载 | 免费
总榜
- 1matlab软件下载入口
- 未知 | 935054次下载 | 免费
- 2protel99se软件下载(可英文版转中文版)
- 78.1 MB | 537798次下载 | 免费
- 3MATLAB 7.1 下载 (含软件介绍)
- 未知 | 420027次下载 | 免费
- 4OrCAD10.5下载OrCAD10.5中文版软件
- 0.00 MB | 234315次下载 | 免费
- 5Altium DXP2002下载入口
- 未知 | 233046次下载 | 免费
- 6电路仿真软件multisim 10.0免费下载
- 340992 | 191186次下载 | 免费
- 7十天学会AVR单片机与C语言视频教程 下载
- 158M | 183279次下载 | 免费
- 8proe5.0野火版下载(中文版免费下载)
- 未知 | 138040次下载 | 免费
评论
查看更多