MAX7356/MAX7357/MAX7358 业内仅有的I

MAX7356/MAX7357/MAX7358 业内仅有的I2C开关，提供总线闭锁检测、隔离和报警指示

The MAX7356/MAX7357/MAX7358 8-channel I²C switches/multiplexers expand the main I²C bus to any combination of 8 extended I²C buses. They enable a master on the main bus to isolate and communicate with devices or groups of devices that may otherwise have slave address conflicts. Any extended bus can be connected or disconnected by control packets from the main I²C bus writing to the main control register of these I²C switches.

The MAX7357 and MAX7358 feature an enhanced mode that includes a built-in timer used to monitor all extended buses for lock-up conditions. If the clock or data line of any of these buses is low for more than 25ms (typ), a lock condition is detected. An optional interrupt can be generated through the bidirectional active-low RST/active-low INT. The master can read the bus lock-up register to find out which extended bus is locked up. The master can also enable the MAX7357 or the MAX7358 to send a "flush-out" sequence on the faulty channel. There is an optional preconnection check that can be enabled to toggle the extended bus clock and data line low then high to ensure the downstream bus is not locked high prior to connecting it to the host bus.

The MAX7356/MAX7357/MAX7358 are transparent to signals sent and received at each channel, allowing multiple masters. Any device connected to an I²C bus can transmit and receive signals; however, only the master connected to the host side of the MAX7356/MAX7357/MAX7358 should address the device.

The MAX7356/MAX7357/MAX7358 are available in 24-pin TSSOP and TQFN packages and are specified over the extended -40°C to +85°C temperature range.

MAX7356/MAX7357/MAX7358关键特性

Bus Lock-Up Detection and Isolation (MAX7357, MAX7358)

Host Notification on Detection of Lock-Up (MAX7357, MAX7358)

Maintain Fault Diagnostic Information (MAX7357, MAX7358)

Dual-Function Active-Low RST/Active-Low INT Provides Lock-Up Notification and Hardware Reset (MAX7357, MAX7358)

Active-Low RST Input Resets I²C Interface (MAX7358)

3 Address Control Inputs

Low R_ON Switches

Logic-Level Translation

Low 0.1µA (typ) Standby Current

Support Hot Insertion

100kbps Standard-Mode or 400kbps Fast-Mode I²C Interface

Address Translation Allows Multiple Device with Same ID

5.5V-Tolerant Inputs

2.3V to 5.5V Supply

MAX7356/MAX7357/MAX7358应用/使用

基站
	流程控制与自动控制设备
	网络设备
	RAID
	服务器
	SFP控制接口